cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
925
Views
0
Helpful
1
Comments
sandsdenver
Level 1
Level 1

Any idea why this TDR wont run on fa ports?

 

#test cable-diagnostics tdr interface ?
GigabitEthernet GigabitEthernet IEEE 802.3z

 

No option for fa ports.


POP29-DIAMSANDS_BLD_10#sh ver | inc image
System image file is "flash:/c3750-ipservicesk9-mz.122-55.SE9.bin"


Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 52 WS-C3750-48TS 12.2(55)SE9 C3750-IPSERVICESK9-M

 

 

 

POP29-DIAMSANDS_BLD_10#sh inventory
NAME: "1", DESCR: "WS-C3750-48TS"
PID: WS-C3750-48TS-S , VID: V05 , SN: CAT1039ZH3L

NAME: "GigabitEthernet1/0/1", DESCR: "1000BaseBX10-U SFP"
PID: Unspecified , VID: , SN: 1311163107

NAME: "GigabitEthernet1/0/2", DESCR: "1000BaseBX10-D SFP"
PID: Unspecified , VID: , SN: 1311165517

NAME: "GigabitEthernet1/0/3", DESCR: "1000BaseBX10-D SFP"
PID: Unspecified , VID: , SN: 1311165516

NAME: "GigabitEthernet1/0/4", DESCR: "1000BaseBX10-U SFP"
PID: Unspecified , VID: , SN: 1311163106

 

sh int cap : FastEthernet1/0/17
Model: WS-C3750-48TS
Type: 10/100BaseTX
Speed: 10,100,auto
Duplex: half,full,auto
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off,on,desired),tx-(none)
Fast Start: yes
QoS scheduling: rx-(not configurable on per port basis),
tx-(4q3t) (3t: Two configurable values and one fixed.)
CoS rewrite: yes
ToS rewrite: yes
UDLD: yes
Inline power: no
SPAN: source/destination
PortSecure: yes
Dot1x: yes

 

# sh int fa1/0/17
FastEthernet1/0/17 is up, line protocol is up (connected)
Hardware is Fast Ethernet, address is 0019.56dc.1f13 (bia 0019.56dc.1f13)
Description: unit-1107
MTU 1546 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 11w5d, output 00:00:01, output hang never
Last clearing of "show interface" counters 01:04:03
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1123
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 4000 bits/sec, 5 packets/sec
5 minute output rate 13000 bits/sec, 4 packets/sec
43291 packets input, 8819123 bytes, 0 no buffer
Received 12 broadcasts (5 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 5 multicast, 0 pause input
0 input packets with dribble condition detected
41513 packets output, 29184901 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out

Thank you.

1 Comment
Leo Laohoo
Hall of Fame
Hall of Fame

@sandsdenver wrote:

Any idea why this TDR wont run on fa ports?


When the "plain" 3650/3750 came out, the hardware was not included in the design. 

Only the GigabitEthernet models supports TDR.  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: