Join us for the next Cisco IOS Advantage Webinar, a 2 hour technical discussion comparing the benefits of Enhanced Interior Gateway Routing Protocol (EIGRP) and Open Shortest Path First (OSPF).
We will discuss EIGRP (DUAL) and OSPF (link state) routing protocols comparing and contrasting a number of considerations such as convergence speed, network design and topology. We will also delve into how each handles the co-existence of IPv4 and IPv6.
This session aims to answer the following questions:
Which routing protocol should I use in my network?
Should I switch from the one I'm currently using?
Do the same selection rules apply to IPv4 and IPv6?
How will my IPv4 and IPv6 routing protocols coexist?
Hello, I have setup an internal network for my Cisco 4948E switch as below: ---switch#enableswitch#conf tswitch(config)#service dhcpswitch(config)#vlan 10switch(config-vlan)#name TMQswitch(config-vlan)#exitswitch(config)#int vlan 10switch(config...
I have an RV345 router. I would like to isolate 4 devices with a VLAN. These devices need internet access and access to each other. However they are not all connected (physically) to the same LAN port. Also there are other devices ...
I'm trying to figure out how exactly nPing works under vManage GUI> Network > Troubleshooting and why RTT shown from its ping output and what the managed router tells me is completely different. I noticed this when I tried to test ping fr...
Hello all. I am new to the networking world, and trying to get a better understanding of everything. I currently have a Cisco Catalyst 4500-X. I am able to to get to the main Switch# prompt, but am realizing that the standard Catalyst commands ...
Dear colleagues, I'm asking you for a help. At the beginning I would like to mention that I don't have experience related with computer networks especially if it comes to work with cisco access points. Week ago I was asked by father of my g...