The standby Cat65 was failed, I convert it to standby then back to VSS.
The standby Cat65 got the following messages then to rommon>
"cisco IOS Software, s72033_sp Software (s72033_sp-ADVENTERPRISEK9-M), Version 12 .2(33)SXI5, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2010 by Cisco Systems, Inc. Compiled Sat 23-Oct-10 02:08 by prod_rel_team Image text-base: 0x40101328, data-base: 0x4231C7C0
System detected Virtual Switch configuration... Interface TenGigabitEthernet 2/5/4 is member of PortChannel 20 Interface TenGigabitEthernet 2/5/5 is member of PortChannel 20 Active crashed three times, disabling auto-boot and dropping to rommon"
This is the messages on standby Cat65:
*Jul 20 23:42:28.571: %SYS-SW2_SPSTBY-5-RELOAD: Reload requested - From Active S witch (Reload peer unit). *Jul 20 23:42:30.083: %VSLP-SW2_SPSTBY-3-VSLP_LMP_FAIL_REASON: 5/4 : Link down *Jul 20 23:42:30.087: %VSLP-SW2_SPSTBY-3-VSLP_LMP_FAIL_REASON: 5/5 : Link down *Jul 20 23:42:30.087: %VSLP-SW2_SPSTBY-2-VSL_DOWN: Last VSL interface 5/5 we nt down
*Jul 20 23:42:30.091: %VSLP-SW2_SPSTBY-2-VSL_DOWN: All VSL links went down whi le switch is in Standby role
Hello.I'm having an issue with SSH console slowness once connected into a network device on GNS3. It generally slow on any router/switch regardless of the configuration to ssh/vty lines.If using Telnet it's perfectly fine and very responsive but ssh is sl...
I'm trying to connect 2 sites to the main office in the middle using VPN I already configured the left side and It works fine but I can't seem to connect the right side to the middle network, here are all the configuration commands i used, !on ...
I'm trying to connect 2 sites to the main office in the middle using VPN I already configured the left side and It works fine but I can't seem to connect the right side to the middle network, here are all the configuration commands i used, !on router...
I'm having an issue with a single VLAN. I have a few VLANs on this switch: 1,4,25,26,30,45. The connected ports are configured thusly: int range ge1-10switchport mode trunkswitchport trunk allowed vlan all My uplink port is ge10My testing port i...
Hello there. I am attempting to setup multiple VLAN's at my church using two SG300-10-10PP managed switches. However, after several attempts and searching the web for examples and instructions, only the default VLAN can access the Internet.&nbs...