The standby Cat65 was failed, I convert it to standby then back to VSS.
The standby Cat65 got the following messages then to rommon>
"cisco IOS Software, s72033_sp Software (s72033_sp-ADVENTERPRISEK9-M), Version 12 .2(33)SXI5, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2010 by Cisco Systems, Inc. Compiled Sat 23-Oct-10 02:08 by prod_rel_team Image text-base: 0x40101328, data-base: 0x4231C7C0
System detected Virtual Switch configuration... Interface TenGigabitEthernet 2/5/4 is member of PortChannel 20 Interface TenGigabitEthernet 2/5/5 is member of PortChannel 20 Active crashed three times, disabling auto-boot and dropping to rommon"
This is the messages on standby Cat65:
*Jul 20 23:42:28.571: %SYS-SW2_SPSTBY-5-RELOAD: Reload requested - From Active S witch (Reload peer unit). *Jul 20 23:42:30.083: %VSLP-SW2_SPSTBY-3-VSLP_LMP_FAIL_REASON: 5/4 : Link down *Jul 20 23:42:30.087: %VSLP-SW2_SPSTBY-3-VSLP_LMP_FAIL_REASON: 5/5 : Link down *Jul 20 23:42:30.087: %VSLP-SW2_SPSTBY-2-VSL_DOWN: Last VSL interface 5/5 we nt down
*Jul 20 23:42:30.091: %VSLP-SW2_SPSTBY-2-VSL_DOWN: All VSL links went down whi le switch is in Standby role
Hello, I have one problem with Cisco prime. I am not getting recent change information from the tab. I have done everything but for no purpose. The picture is attached. Please guide me so that I can check my recent changes in cisco 2960. Cisco ...
How a switch can recognize traffic as “video” and what knobs inside a switch are available for a network designer to achieve this requirement???There are Media net on the switch that can automatically detect the device type connected to the...
Hi all. For a couple of years I've had two Cisco 1941 routers running IOS and BVI interfaces to support some end user devices. I have two Cisco ISR4321 running IOS-XE which from what I've read you must do BDI interfaces. I attached a diagram and applicabl...
Dear all,Now I have been investigating whether Cat65-MSFC can configureNetFlow NAT record or not. For instance other vendor such as FortiGate can support so I think Cisco might support for this.https://docs.fortinet.com/document/fortigate/6.0.6/handb...
Hello, I have to change a Cisco 3845 and install a Cisco ISR 4451. The problem is I have a subinterface with 30 helper-address: When I insert more than 16 directions using helper-address command, I have an error message which says that the router does not...