Vivek Baveja brings more than 17 years of networking technology and management experience across enterprise and service provider verticals. He is currently a technical marketing engineer with Cisco Catalyst Series switching products with a focus on backbone, core, and distribution across Layer 2, Layer 3, Multiprotocol Label Switching (MPLS), DCN, telecommunications, and newer technologies across hardware and software, enabling the enterprise for the next generation of networks. He holds a bachelor of electronics engineering, CCIE, and management degree from the Wharton School of Business.
During this live event, Cisco subject matter expert Vivek Baveja provided an overview of the key components, design details, and operational benefits of using a Cisco Catalyst 6800 Virtual Switching System (VSS) with quad-sup SSO, along with the new campus FEX technology Cisco Catalyst Instant Access (CIA).
During the live webcast, following topics were covered:
Overview of Cisco Catalyst 6800 Series Hardware
Overview of Cisco Catalyst VSS design and benefits
Overview of Cisco Calalyst CIA design and benefits
Hi Team ,I am very much confused about BGP table ...I m still not sure it's BGP rib table or BGP routing table ..I came in this situation while performing LAB in eveng. My set up was mpls ( ldp ) core and PE _CE was running EBGP . C...
Sometimes network engineers underestimate the importance of the interconnection link between the distribution layer switches at the distribution block of the enterprise campus network. There are two options to design the Distribution-to-Distribution Link:...
Hello, I didn't realize and installed Amsterdam version 17 to my 9200 which was running Gibraltar 16.12.04 y was supposed to install Gibraltar 16.12.5 but I messed it up.I ran the install activate command but didn't go for the reload when prompted to...
Hello team, After scanning vulnerabilities at the Cisco DNA Center, it was found that: - Replace the 'Diffie-Hellman' with a safer group; - Increase the private key to 2048 bits or more. I couldn't find documentation with steps on how ...