Connected to the console port I was getting the following messages over and over again. In my case vlan 23 went to the WAN port on a IPS server and vlan 200 went to the LAN port on the same server. It is not a switch but I was told because it was crossing vlans cdp was reporting the issue even though it wasn't a problem.
Mar 9 23:15:26.022: %CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/3 (200), with 3750X-CS.kbsi-cs.com GigabitEthernet1/0/2 (23).
Mar 9 23:15:30.971: %CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/2 (23), with 3750X-CS.kbsi-cs.com GigabitEthernet1/0/3 (200).
interface GigabitEthernet1/0/2 description Sentinel - WAN switchport access vlan 23 switchport mode access end
3750X-CS#sh run inter g1/0/3 Building configuration...
Current configuration : 133 bytes ! interface GigabitEthernet1/0/3 description Sentinel - LAN switchport access vlan 200 switchport mode access end
In this case everything was working as designed. The notification was because the ports were connected to the same device crossing vlans. So we applied "no cdp enable" on both interfaces and the logs messages stopped.
I have two 5672UP Nexus switches setup as VPC peers, both running NX-OS 7.3(5)N1(1). I have enabled the peer-switch command and equal spanning tree priorities for all vlans that support the VPC members. I have also confirmed that a...
Can someone please help me? I don't seem to know why this router has two default routes in the running config. Please see below ro-1.gbr.amsterdam#show running-config | i ip routeip route 0.0.0.0 0.0.0.0 192.168.1.254 254ip route 0.0.0.0 ...
Hi there, i'm not able to ocnfigure "enable secret" or even "service password-encryption" commands on the cli of my SG350X switch. Is the CLI really so much cut-off or do i try to use obsolete commands?
Description: SVI stopped working in many switches of my inside network but some switches are still working fine. There is a difference of days and hours from 1 switch to other switche when SVI stopped. I tired all the possible solutions from blogs/google ...
Hi Guys, Any of you had any experience using AMP with the SD-WAN Solution? I've recently been entitled with a Threat Grid Account and since then I'm not able to configure any device that has the security policy with AMP configured. The erro...