The Cisco 2800 Series routers are designed for wire-speed delivery of highly secure concurrent services and can accommodate multiple T1/E1connections for services including:
The integrated services routing architecture of the Cisco 2800 Series provides the performance, availability, and reliability needed to scale mission-critical business applications in the most demanding environments. Features of the routers include:
Cisco Router and Security Device Manager (SDM) for simplified management
A modular platform with a broad range of interface options
Up to 2 10/100/1000 Mbps built-in routed ports
Up to 64 10/100 Mbps switch ports with optional Power over Ethernet (PoE), for providing DC power to network devices such as IP phones
Cisco CallManager Express (CME) call-processing support for up to 96 Cisco IP phone users
Cisco Survivable Remote Site Telephony (SRST) support for up to 96 Cisco IP phone users, allowing the router to provide call-processing functionality to keep voice service in operation should the connection to Cisco CME be lost
What is the difference between "isis three-way-handshake ietf" and "isis three-way-handshake cisco" ? When I did packet capture with isis three-way-handshake ietf there were extended local circuit ID , Neighbor system-ID and neighbor...
We have a hub and spoke router but connection should work only when primary connection at the site fails however I run to a issue that from hub we are fording the traffic via the tunnel instead via the private connection.As checked between working and non...
Hello,I hope you and your loved ones are safe and healthy. I am want to integrate a Cisco Integrated Service Router "RV-345" into my network & use VLAN to segregate traffic. Current setup:Netgear Wi-Fi router is the only component carrying o...
I am now working on Catalyst 9200L-24T-4G and 48T-4G switches. When I tried to configure trunk ports, the option switchport encapsulation dot1q/isl doesn't exist. Then I looked for data sheets and there isn't any mention about ISL, but...
Hello everyone,I have N9K-C93180YC-EX that connected to two computers on the same subnet.I want to add Time stamp on the data and when I open Wireshark on the receiving PC I will see Time stamp tag on it. I read the data page on PTP and followed...