Viptela provides a compelling SD-WAN solution with advanced routing, segmentation and security capabilities for interconnecting complex enterprise networks. Its cloud-based network management, orchestration and overlay technologies make it easy to deploy and manage SD-WAN.
Scenario 1 – An overview of the SD-WAN vManage dashboard and discussion around Zero Touch Provisioning (ZTP) capability. Branch site routers, with design best practices, can easily be provisioned by leveraging automation through zero touch provisioning and centralized configuration. Centralized configuration utilizes the templates that can be pre-configured before device deployment
Scenario 2 – Use the Hybrid WAN connectivity over multiple WAN transport connections. Show connectivity could be established over any kind of transport, application steering over any transport. Using IP as transport to create flexible data plane topologies from full-mesh to Hub-n-Spoke to any arbitrary topologies
Scenario 3 – Demonstrate business defined insertion of services (FW, IPS, IDS, etc) utilizing centralized policies. Flexible architecture where services can be deployed in any of the site(s) irrespective of the physical topology. Simple policy activation can make selected applications and sites to go through the required service
Scenario 4 – Show the simplicity of using application firewalling policies centrally. Various applications and/or flows would not be allowed between sites. Simple centralized policy activation would enforce such policies to any site on the overlay
Scenario 5 - Use the Application aware routing along with arbitrary topology networking to show the business policy driven view of application classification, connectivity and QoS provisioning. Discuss Application Performance settings while highlighting the ability of the network to dynamically switch paths to preserve a consistent application experience
Scenario 6 – Policy driven Data Center preferences for different branches. A subset of branches could prefer one Data Center over the other as a regional Internet exit
Hi FolksI have this design implemented for a client; FB1- F1 (eBGP)FB2-F2 (eBGP)FB1-FB2 (iBGP)I have imported some enterprise routes ( data center routes) into corporate VN, however, Fusion must also have reachability to those Corporate network ...
Good Evening,i increased the dhcp network scope from 192.168.1.0/24 to 192.168.0.0/22 on a cisco 1941 router ... My PCs can connect to DHCP and internet but my polycom phones are unable to register to polycom after getting IP Address in the range 19...
I am in the process of writing up an EEM scrip for an ASA to do a scheduled backup. I have found a few references for this, but I ran into an issue with one of my ASAs giving a "Resource temporarily unavailable" message which ended with "ERROR: Back...
Hi All, I was wondering what is the best practices followed for Enterprise WAN connections in the following scenario1) Own APNIC Public IP pool2) TWO ISPs for Redundancy (Multi-homed)3) ISR routers being used for BGP with both the ISPs&nb...
Hi, on an 2960XR at one of our branches there are three vlans: 5 (management), 10 (data), 20 (voice). Switch is uplinked to a MPLS carrier CE, which is gateway for all three networks. Switches management IP address is 192.168.5.2, default gatew...