Dynamic Personalized IP Services at the Network Edge
Deploy high-performance IP (Internet Protocol)/MPLS features as well as scalable personalized IP services at the network edge, improve operational efficiency, and maximize return on network investments with the Cisco 7600 Series Router.
The Cisco 7600 Series is the industry's first carrier-class edge router to offer integrated, high-density Ethernet switching, carrier-class IP/MPLS routing, and 10-Gbps interfaces, benefiting enterprises and helping enable service providers to deliver both consumer and business services over a single converged Carrier Ethernet network.
High performance, with up to 720 Gbps in a single chassis, or 40 Gbps capacity per slot
A choice of form factors purpose-built for high availability
Cisco I-Flex design: A portfolio of shared port adapters (SPAs) and SPA interface processors (SIPs) that controls voice, video, and data experiences
Scalable and extensible suite of hardware and software capabilities to enable intelligent Carrier Ethernet services
Integrated Video Call Admission Control with innovative visual quality of experience for both broadcast and video on demand (VoD)
Intelligent Services Gateway, providing scalable subscriber and application awareness with multidimensional identity capabilities and policy controls
Integrated Session Border Control with quality of experience in both Session Initiated Protocol (SIP) and non-SIP applications
Carrier Ethernet: Aggregation of consumer and business service
Ethernet services edge: Personalized IP services
Wireless mesh networking and mobility service convergence
Hi Guys, Got a strange issue between our core switch SX550-48 to our edge switch SX350-48. We use 4 copper links between the edge and core in a single port channel. The core switch shows all physical links up but the edge side is down. Not sure what ...
Something very strange started happening. I'm looking for a sanity check. We currently use a Radius-As-A-Service to provide authentication for our VPN on a Cisco ASA and ASDM access to that same ASA. Nothing changed on the radius side at all.&nb...
We see this issue quite often, we're staging an MSTP deployment of an NCS2006 M6 with dual TNC-Es, and we constantly lose connection to the shelf in CTC, making it difficult to setup some initial configuration parameters. This issue occurs on multiple she...
Hi, I want to make a PBR with asa 5520 with ios 9.1.x, but I can not put the set ip next-hop command Configuration aclaccess-list acl-pbr-dmz extended permit ip host 18.104.22.168 anyPbr configuration route-map pbr-dmz permit 10match ip addr...
We bought Anyconnect license but when we contact licensing team to help us, a person said to us Anyconnect License doesn't work on our system (see above pls) but Another person in licensing team said to us it will work, which is true, we are very co...