Looking for a little help. I have just received several of the switches above to install onto my network. This is the first time I have used Managed Switches. So I used the documentation to connect to the switch and enter Express Setup. I give the Switch an IP address, the Subnet of my network and the default gateway and also give it a host name, then I save this information.
Unfortuantly after this I can not see the Switch on the IP Address I have assigned or the default IP address of 10.0.0.1. I have made sure all the information i have entered into the switch is correct, I have even rest the switch and started again, but still the same thing happens. I thought it may be the switch itself, so I tried another switch, but the same thing happens. I am a little lost.
The switch itself is working, as I have connected devices to the switch and I can ping the device itself, I can ping to the device and from the device on the switch to anywhere on the network, I just cant ping the switch itself.
I'm trying to get a 2960g IOS 15.0 to bring up its management vlan without an interface specifically assigned to it. The uplink trunk has the vlan listed as allowed but the vlan interface itself won't come up.All the physical ports are assigned to differe...
Hi everyone. I have a BGP query that I've inherited which I hope someone can help me with. My company has a WAN MPLS circuit across Europe (provided by Verizon). There are 6 remote offices with the UK Data Centre in Hampshire, UK. We want to reg...
Below is my requirement.Scenario:I have DC & the Branch location#1 connected via SD-WANDC & Location #1 has Internet link & MPLSDC advertises network 10.10.100.0/24 to location#1. Location#1 learns the network via OMPI have attached the diagra...
Need your guidance.Which Stack cable can be used for cisco switch stacking of C9200L-C9200L and C9500L-C9500L.Kindly share the difference, if possible also share the image of cables with name so that i can understand it well. Thanks