The input packet queued rate is greater than the minimum packet rate, and the input packet discard percentage is greater than the discard threshold.
The input packet queued rate is the rate of packets received without error. The input packet discard percentage is calculated by dividing the rate of input packets discarded by the rate of packets received.
The output packet queued rate is greater than the minimum packet rate, and the output packet discard percentage is greater than the discard threshold.
The output packet queued rate is the rate of packets sent without error. The output packet discard percentage is calculated by dividing the rate of output packets discarded by the rate of packets sent.
To resolve this issue, determine the threshold on the CiscoWorks Device Fault Manager (DFM). It can be set too low or too high, and cause alarms.
To check the thresholds in DFM, perform these steps:
Select Administration console > Edit > Polling and Thresholds.
A Polling and Threshold window opens.
Select the Threshold tab located at the bottom left of that window.
Expand DFM on the left pane and select the router.
Select the appropriate group for Interface Groups, and click on the entries under that group one by one.
Check the threshold values set for various events on the right-hand side.
Make sure the thresholds are appropriately set for the router, based on the network conditions.
If the alarm continues to come up, set a filter in the DFM to determine if it is a device failure.
Hi all, I am facing very strange problem in my setup. I have two routers (1 cisco 4431/k9, 1 cisco 2900) both are connected point to point via service provider and there is a lan behind the router both the side.I have configured the default route on ...
Hi Frineds,I am having issue with integration between Cisco and Hirschman switches. there is different pattern of cisco mrp domain-id which is FFFFFFFF-FFFF-FFFF-FFFF-FFFFFFFFFFF and in Hirschman 255.255.255.255.255.255.255.255.255.255.255.255....
Hi Everyone, I am trying to ping from PC10 to PC-class1-internet but i am unable to do so . I have configured OSPF protocol on both the routers (R1 & R2) and all on the interfaces but still cant. THe network topology is atta...
Dear All, I am implementing an inter-tenant firewall and I would like to know what the most efficient way of setting up the routing would be. Basically, I need to route between a main VRF and several protected VRFs using a firewall to hop between the...
Hi everyone - i'm trying to find TCP script to shutdown 150 tunnel interfaces/clear crypto session on the main router and unshut them on a backup router RouterA:Interface Tunnel200shutdowndo clear crypto session remote 220.127.116.11Interface Tunnel300shutd...