Refer to Understanding ACL on Catalyst 6500 Series Switches for more information in order to understand Access Control List (ACL) Merge Algorithms and ACL Hardware Resources on Cisco Catalyst 6500/6000 series switches.
What design is generally recommended for an office with approx 400 client devices. We have about 10 x access L2 switches (2960x) and are not sure whether to go with 1 x L3 stack (4 x 9300 switches) or maybe 2 x stacks (of 2 x 9300 switches). We are thinki...
view more
After I create a VLAN i can no longer access the GUI.port 1 - trunk connected to routerport 2 - access, PCThe switch is connected to an Edgerouter.I'm sure it's something simple, but I'm new to VLANs and can't figure it out.
Hi Folks, I have posted my config below for a little advice/suggestions.This is 1 of 2 Cisco 887 routers which feed into a Cisco 2960 switch were I have mapped the access ports to VLANs as below. I have a few questions as I had planned to use Ether C...
view more
Hello all. Some of my friends telling me that I am using stateless method for my Dhcp router and some of them telling me that I am using stateful method. I attached the packet tracer for references.This is the current configuration: A...
view more
Hi Everyone, I want the centre administration & tutor computer to not be able to access the internet but can access web and file server. I have tried this coding but it doesn't work. access-list Filter1deny tcp host 2001:AAAA:BBBB...
view more
