In this example we just installed 2 2-port VWIC-MFT cards, one is slot and one is slot 3. Once installed you'll notice no additional serial interfaces nor controller cards. However a show inventory shows the cards are installed.
clock source line independent <--- in the case it is not internal channel-group 0 timeslots 1-24 ! controller T1 0/3/1 framing esf linecode b8zs
clock source line independent <--- in the case it is not internal channel-group 0 timeslots 1-24
The reason for the "independent" keyword is to have the interfaces in the VWIC card to work with separate "clocking domain" one from the other.
Now that we have the controllers configured you should see 4 new serial interfaces.
Serial0/2/0:0 unassigned YES manual down down Serial0/2/1:0 unassigned YES manual down down Serial0/3/0:0 unassigned YES manual down down Serial0/3/1:0 unassigned YES manual down down
Now we can configure the serial interfaces.
interface Serial0/2/0:0 no ip address encapsulation ppp multilink ppp multilink group 2
interface Serial0/2/1:0 no ip address encapsulation ppp ppp multilink ppp multilink group 2
interface Serial0/3/0:0 no ip address encapsulation ppp ppp multilink ppp multilink group 2
interface Serial0/3/1:0 no ip address encapsulation ppp ppp multilink ppp multilink group 2
Finally let's configure the virtual MultiLink2 interface.
interface Multilink2 description MLPPP Link for Point-To-Point ip unnumbered FastEthernet0/0 ip route-cache flow no ip mroute-cache ppp multilink ppp multilink links maximum 4 ppp multilink group 2 ppp multilink fragment disable
I tried to use "secret 0" followed by an unencrypted secret. But then when I tried to access the device the password is not being accepted. In the example below - should not the password foruser skipper be foo123? username skipper pri...
Hi,I have the SG350X with inter-VLAN routing disabled. It is trunked to another switch that works as the router. No static routes are defined on the SG350X since I would like it to behave like an L2 VLAN aware SwitchWhen I try to access VLAN 1 management ...
Hello all,I am having an issue to which I have not really be able to find a cause or resolution. The OSPF neighbor relationship between 2 routers keeps dropping, then immediately reforming the adjacency.ROUTER1GW#May 13 13:35:51 EDT: %OSPF-5-ADJCHG: Proce...
Hello, I am wondering about the following scenario and if it falls under a best practice. Two locations and each location is identical in terms of equipment and purpose. Let's say location A had a vlan 100 with 188.8.131.52/24 would location B best be ...
Hello Team,I have two vEdge virtual routers in Azure and I need a server that's behind them to be publicly available. Has anyone config'd this yet? I think I have a good understanding of what I need to do but figured to throw this out there.