It is observed that the device can crash when you use the Remote Network Monitoring (RMON) to copy a configuration to the running configuration. In some scenarios, it is seen that if the power-off-switch comes back with power-on, the whole stack crashs and reloads.
This symptom is observed on a Cisco routers that runs a Cisco IOS software image that integrates the fix for Cisco bug ID CSCeg74543, which says Cisco IOS images after Cisco IOS Software Release 12.2(25)S can see configuration sessions become unresponsive.
This problem is documented in Cisco bug ID CSCsd37284.
In order to resolve this problem, you can upgrade to Cisco IOS Software Release 12.2(35)SE1, which can be downloaded from Cisco Downloads.
If an upgrade is not immediately possible, then the only workaround is to disable RMON. Refer to the Configuring RMON for more information.
I'm a little confused so I have one host that is 10.10.0.100 on vlan 1 with an SVI of 10.10.0.1/16 and I'm trying to ping vlan 100 with ip address 192.168.70.150 and an SVI of 192.168.75.1/24. The way it's laid out is I have a layer 3 Cisco switch directl...
i have cisco c2960-48lps-L Switch. i downloaded new IOS to switch and tried to install via XMODEM after IOS file is copied Successfully to the flash. after boot my IOS file switch started automatically restart and iOS install again this is the last masseg...
Hi guys,Can someone tell me what is the difference between these two extended ACLs?1) permit udp any range 8801 8810 192.168.0.0 0.0.255.2552) permit udp any 192.168.0.0 0.0.255.255 range 8801 8810 Thank you!
Cisco Secure Network Access is helping IT to bridge the gap between what is essential to the business and what the network delivers and to build the next-generation campus network for an unplugged and uninterrupted experience.
Learn more about how these w...