INSTALL LICENSE ON CSR 1000v ( for security license, other license also same method) ====================================
Step 1: copy the license file to CSR1000v Step 2: Install the license
Router#license install bootflash:9XXXXXX_XXXXXXXX.lic Router#sh lice detail Index: 1 Feature: sec_5G Version: 1.0 License Type: Permanent Start Date: N/A, End Date: Jun 15 2020 License State: Active, In Use License Count: Non-Counted License Priority: Medium Store Index: 0 Store Name: Primary License Storage
Step 3: Router#config t Router(config)#license boot level security Router(config)#license accept end user agreement Router# write memory Router#reload Router# Router# Router# show verison Router# sh platform hardware throughput level The current throughput level is 5000000 kb/s Router# Router#
///summary license install bootflash:9XXXXXX_XXXXXXXX.lic conf t license boot level security license accept end user agreement end wr me reload
if the throughput level is not changed from 100kbps(default) then use the manual method( below command). /--------------- conf t platform hardware through level MB 5000 end wr me
show platform hardware throughput level >> it will show the
If still not shows the correct throughput level reload the Router
Hello,I have an ISP WiFi router that is limited to only one port, even though there are 4 ports on this ISP's router. Please refer to the diagram: (1) The yellow router is a TP-LINK AC1750 (A7) situated in another house 50 meters away.(2)...
In my enviorment i want to delpoy thirdparty Network Managment system on Hyper-v for SNMP monitorning.For high Availability i want to install Primay and Standby Netowrk Management Server on Hyper-V Cluster. we will use share storage for both s...
When we connect LAN core to WAN via Fa0/0 then we assign Vlan to Fa0/0 of Lan CORE at access mode and then we run ospf between LAN core and WANBut we can assign IP to interface of both LAN core & WAN so why we assign IP via SVI?ANY reason