INSTALL LICENSE ON CSR 1000v ( for security license, other license also same method) ====================================
Step 1: copy the license file to CSR1000v Step 2: Install the license
Router#license install bootflash:9XXXXXX_XXXXXXXX.lic Router#sh lice detail Index: 1 Feature: sec_5G Version: 1.0 License Type: Permanent Start Date: N/A, End Date: Jun 15 2020 License State: Active, In Use License Count: Non-Counted License Priority: Medium Store Index: 0 Store Name: Primary License Storage
Step 3: Router#config t Router(config)#license boot level security Router(config)#license accept end user agreement Router# write memory Router#reload Router# Router# Router# show verison Router# sh platform hardware throughput level The current throughput level is 5000000 kb/s Router# Router#
///summary license install bootflash:9XXXXXX_XXXXXXXX.lic conf t license boot level security license accept end user agreement end wr me reload
if the throughput level is not changed from 100kbps(default) then use the manual method( below command). /--------------- conf t platform hardware through level MB 5000 end wr me
show platform hardware throughput level >> it will show the
If still not shows the correct throughput level reload the Router
Wondering if anyone else is having my problem? If not, just posting this to let you know you're not alone. I have three circuits at all my sites. When one ISP is having an outage, the ISP modem is still up and vManage shows Up/Up, vManage still...
Thank you to anyone able to help us establish our Gateway to Gateway VPN between 2 RV325sHere's the ugly log entries at location 1 that come up when I hit connect:packet from 220.127.116.11:500: [Tunnel Authorize Fail] no connection has been authorized w...
Trying to find a way to do local internet breakout on the vEdge or cEdge but without using NAT. Meaning this will be connected to a firewall; which acts as the local ISP, and then the FW will be doing the NAT. All documentation I've seen on Cisco show onl...
I've been trying to work on finishing tshoot before the 24th. I have a live lab that I use and I'm working on using regexp's. I would like to filter the "show interfaces description" command to only show interfaces that actually have descriptions. That is...
Hello, I accidentally pushed the 'no exec' command on a couple switches remotely and unfortunately it saved the config too! Obviously I do not had access to the switches now so I was wondering if anyone knew of a way to fix this without wiping the sw...