In a Catalyst Express 500 switch, the Device Manager does not show utilization on the ports; it shows 0% port utilization. This is because on the Catalyst Express 500 monitoring tools, any traffic loads under 10% do not register in the Device Manager monitoring tools.
If you need to monitor traffic levels under 10%, use the mechanisms provided in the Cisco Network Assistant (CNA) software.
CNA is a free software program that can be downloaded from Cisco.com and run on the PC. CNA offers advanced options to configure and monitor multiple devices. In order to download the CNA application, refer to Cisco Network Assistant.
been shearing the KB but can't seem to find the the correct reference is the throughput level in router shared between ingress and egress? if i have 400M throughput this will be shared inbound and outbound traffic? thank you
One question I've often asked myself but haven't been able to find an answer to yet... When a switch enabled with STP boots up, all switch ports transition through a series of STP port states before finally reaching a forwarding state (for ...
Hi All, I was hoping someone could assist me in explaining what the function is of the below commands on a cisco switch interface? srr-queue bandwidth share 1 30 35 5priority-queue outmls qos trust cosauto qos trust Many Thanks! Kind R...