Following command can be used to turn on/off DOM for all transceivers type in the system
Router(config)#transceiver type all
Once enabled, DOM can be accessed via CLI using "show interface transceiver command"
Off all the five values two mostly used and rellevant values are TX and RX power, temperature is also used sometimes. The operating range of these three values is unique across all modules and is available in the data sheet.
There is an extension available for this command, which is also very helpful and is used to check threshold values of the above paramaeters like temperature , Tx, Rx. The command is , show interface gig x/y transceiver detail
sh int gi 1/3 transceiver detail
Transceiver monitoring is disabled for all interfaces.
ITU Channel not available (Wavelength not available),
Transceiver is externally calibrated.
mA: milliamperes, dBm: decibels (milliwatts), NA or N/A: not applicable.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
A2D readouts (if they differ), are reported in parentheses.
The threshold values are calibrated.
High Alarm High Warn Low Warn Low Alarm
Temperature Threshold Threshold Threshold Threshold
Port (Celsius) (Celsius) (Celsius) (Celsius) (Celsius)
Hello,I just wanted to ask if there a possibility to configure SSL VPN in Cisco Packet Tracer on such a routers like 1841, 2811 or 2620 or if there is a possibility at all. Tried to configure it somehow, but some commands are not avaliable. Cheers
I want to implement OTV in my network with the ASR routers. But as usual, I am testing and studying it in my VIRL lab first. First of all, there is no ASR in VIRL. I am using CSR instead. I am assuming that the behavior would be the same between the ASR a...
I’m looking for a way to explicitly allow certain VLANS to be routable. In this example I would like VLAN 25&35 to talk but 25 cannot communicate with another vlans. I would like to apply the rule to VLAN 35 that way I don’t have to r...
Dear Team,I am planning to purchase the Cisco VPN router RV042. please help me to answering the below question. 1.> I have 100 Mbps internet connection in my office. if i purchase the this VPN router how much bandwidth i will get through the VPN ....
Hello thereAlthough it's not a new topic, but I think there is a need to clarification. Could someone please inform us about ISR 4000 different licenses ? - We know technology licenses ( Sec, AX, ...) are all RTU, right?- What about performance (Thro...