Following command can be used to turn on/off DOM for all transceivers type in the system
Router(config)#transceiver type all
Once enabled, DOM can be accessed via CLI using "show interface transceiver command"
Off all the five values two mostly used and rellevant values are TX and RX power, temperature is also used sometimes. The operating range of these three values is unique across all modules and is available in the data sheet.
There is an extension available for this command, which is also very helpful and is used to check threshold values of the above paramaeters like temperature , Tx, Rx. The command is , show interface gig x/y transceiver detail
sh int gi 1/3 transceiver detail
Transceiver monitoring is disabled for all interfaces.
ITU Channel not available (Wavelength not available),
Transceiver is externally calibrated.
mA: milliamperes, dBm: decibels (milliwatts), NA or N/A: not applicable.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
A2D readouts (if they differ), are reported in parentheses.
The threshold values are calibrated.
High Alarm High Warn Low Warn Low Alarm
Temperature Threshold Threshold Threshold Threshold
Port (Celsius) (Celsius) (Celsius) (Celsius) (Celsius)
I cannot access console port of RV260W switch . no response from router and stuck at black screen console setting are default 9600 baud rate. what is the console setting for this router? i cannot see any where in cisco document mentioned about i...
Dear all.Maybe some one can help me quick. We install Cisco Prime Infra. for an Test Pilot und we recognize that we can not see Google Maps Map in the back. Maybe some one can give me tips how to troubleshoot this issue ? Thanks in advanced !&nb...
I am looking for Centralized DNAC deployment for Assurance purposes and Sd-Access. We have 3 sites and each site has 2000+ endpoints and 50 network devices. Sites are connected over IPsec with 50-70ms latency. So, what are the best deployment strategies f...
Am doing some beginner labwork and am stumped on something that has to be really simple.....hasnt it! I can configure ip addresses in router port f0/0 & 0/1 not a problem using the following series of commands However when I try ...
I have two geographically distinct sites, each with an ASA5506, that I am trying to connect via BGP. Please see the attached diagram belowMy work so far has been succesful. Both ASA's have BGP enabled, and have Established connections to the common A...