This document provides a sample configuration on how and when to use distribute-list out command. This command only works on the routes being redistributed by Autonomous system boundary Router into OSPF. It can be applied to external type 2 and type 1 routes, but not to intra-area and interarea routes..
It is assumed that a person reading this document is familiar with Ospf.
For this document 3700 Series router with IOS 12.4(18) loaded in it.
The configuration files are attached with this document.
For this example, loopback interfaces connected to Router R1 will be redistributed in the ospf domain and R1 will serve as ASBR (see configuration attached for reference) .
We will filter network 188.8.131.52 from Area 1 for this example.
Before we move forward, lets take a look at the routing table of R3:
And, we can surely see network 184.108.40.206.
Now for filtering network 220.127.116.11 from area 1 we need to perform two tasks
We first need to configure an access-list to filter this particular network out.
Second, we need to apply that filter
This will be done at router R1, which is the ASBR for this OSPF network.
For step 1, we will create an access-list which will deny net 18.104.22.168/24 and permit all others:
For step 2, we will apply this filter:
Lets see the routing table of Router R3:
We surely don't see 22.214.171.124 network on R3. And, to prove that R2 is not sending type 5 LSA for this network in area 1, lets see the database for 126.96.36.199 network on R2:
Ask Me Anything Forum
This event is a chance to review and understand the technical details of SLP, the Greenfield and Brownfield scenario, deployment details for devices, the new Cisco Smart Licensing utility (CSLU), and controllers (CSLU, CSSM Clo...
I have network that is connected as follows: 9006 router is BGP peering to another 9006 router upstream over a port-channel. Then the 9006 router locally hands off the Internet connection to an aggregation ios xe 903 router which hosts BDI...
Hello all, i've been trying to configure a port to use POE on a Forti AP.i've see the configuration and when i try to configure the power inline on the port i cant and the only option i have is " efficient-ethernet"
Hello,I have a FTD 2130 in lab for testing (v6.7).I would like to know if one can use management interface to route traffic? Another question is: this interface can also use data interface as gateway. What are the use cases for this option?what are t...
I have a multihomed scenario with two routers connected to two different ISP's.The inside interfaces of the routers have VRRP configured and are both connected to the same switch.IP SLA reachability is set up to track reachability to 188.8.131.52 in the ...