This document provides a sample configuration on how and when to use distribute-list out command. This command only works on the routes being redistributed by Autonomous system boundary Router into OSPF. It can be applied to external type 2 and type 1 routes, but not to intra-area and interarea routes..
It is assumed that a person reading this document is familiar with Ospf.
For this document 3700 Series router with IOS 12.4(18) loaded in it.
The configuration files are attached with this document.
For this example, loopback interfaces connected to Router R1 will be redistributed in the ospf domain and R1 will serve as ASBR (see configuration attached for reference) .
We will filter network 126.96.36.199 from Area 1 for this example.
Before we move forward, lets take a look at the routing table of R3:
And, we can surely see network 188.8.131.52.
Now for filtering network 184.108.40.206 from area 1 we need to perform two tasks
We first need to configure an access-list to filter this particular network out.
Second, we need to apply that filter
This will be done at router R1, which is the ASBR for this OSPF network.
For step 1, we will create an access-list which will deny net 220.127.116.11/24 and permit all others:
For step 2, we will apply this filter:
Lets see the routing table of Router R3:
We surely don't see 18.104.22.168 network on R3. And, to prove that R2 is not sending type 5 LSA for this network in area 1, lets see the database for 22.214.171.124 network on R2:
Hi All,I am configuring license on cisco router 4321 ISR via generated token. but license is not activating on that router.We have smart account and created Virtual account on cisco Smart account portal and then generated a token for the registratio...
Hi All,I am configuring license on cisco router 4321 ISR using Token generated. but router is not activating license. We have smart account and created Virtual account on cisco Smart account portal and generated a token for the registration of ...
When I connect my PC directly with my Router (peer to peer), I get a speed of upto 39 Mbps which is the service provider plan I subscribed. However, when the PC is connect to a WiFi network hosted by the same router, the speed drops to 25 Mbps. Cisco Rout...
Hi I have a small SDA Lab with DNAC version 126.96.36.199I have a single Border/Control plane node that is connected to a Fusion router and out to the internet. I cannot get out to the internet.When I created the Border/control plane switch I don't r...
I have a very strange problem when I connect the router to the internet and consult any page after a few seconds the connection goes down I restart the internet mode I have connection and again the connection goes down