There are basically three types of versions which shows up when you issue the show module command:
Hardware version (Hw)
Software version (Sw)
Firmware version (Fw)
HW and FW versions are codes that the manufacturer handles on some chips of different types of cards. These information comes from factory and cannot be changed.
The differences in these versions does not affect any kind of compatilibity, when installed in a same chassis. The only thing you need to make sure is that the software that runs in the Supervisor needs to support the line cards so that they are recognized.
I have read that they are used for router id election or to check if the router is active. If the router has all its interfaces turned off what do I need to ping the router interfaces? the interfaces are all off ..... Besides these reasons, are there any ...
Hello, I'have a nexus Nexus9000 C93180YC-FX. I using it to do BGP and some small routing. It crashing every months, with error : edge01.par9k# show ver
Cisco Nexus Operating System (NX-OS) Software
BIOS: version ...
Hii, I have recently purchased RV340 Dual Wan Giga router for my office space which I intend to use with the existing 2 ISPs. The problem I am facing is that my primary ISP ( Airtel Xstream Broadband ) let's say ISP1, provides an inbuilt GPON ...
Dears, I have a query that i saw one option of "bind interface(Gigabitethernet 0/0/0)" while configuring loop back WAN link. Interface Loopback1tunnel-interfaceencapsulation ipsec color private1 bind Gigabitethernet 0/0/0what does it m...
With the help of the orbilogin.com web interface, a user can set up a Guest network that allows visitors visiting your home to use the Internet without typing the Wi-fi password in the provided field. Creating a guest network is a smart way to allow users...