Embedded Event Manager (EEM) is a powerful tool integrated with Cisco IOS Software for system management from within the device itself. EEM offers the ability to monitor events and take informational, corrective, or any desired action when the monitored events occur or when a threshold is reached.
This document helps in getting output of various troubleshooting commands when EIGRP neighbour flaps through EEM script.
Knowledge of EIGRP and working of EEM script.
Step 1:telnet the router.
IMPORTANT: console access is not reliable and will miss characters when copy/pasting, telnet/ssh using TCP will take care that all characters are received.
Trying to route between two networks using ONE Cisco 1951 router. 192.168.0.x on G 0/0, and 192.168.1.x on G 0/1.config tint g 0/0ip address 192.168.0.1 255.255.255.0ip route 192.168.1.0 255.255.255.0 g 0/1no shutdownexitconfig tint g 0/1ip address 192.16...
Hello all,i'm having some trouble on a lab with this topology Both Loopback1 are redistributed into OSPF (so they are E2).From R1, i can see this routing table (ospf)So, in order to reach 22.214.171.124 (that is IA) i will pass through R3 (so via area 0), while ...
I have a Cisco catalyst 2960 switch si Poe-8. I’m new at this and have a question. My switch is set up with up vlan IP address 192.168.0.1. I have a WiFi router plugged into the switch the router uses 126.96.36.199. If I plug a ip camera into th...
Hello! I'm trying to wrap my head around NAT rules and how the system processes them. I understand that the manual NAT section comes before the auto / object NAT section which comes before manual NATs that we deprioritize. &nbs...
I am new to BGP. We have established BGP neighborship with 2 uplink providers advertising different networks and receiving default routes from both using same AS number. We couldn't establish iBGP as we have a requirement to use both ISP A and ISP B for s...