Join us for the next Cisco TechAdvantage Webinar, a 1-hour technical discussion on Media Services Proxy (MSP) for enhanced media awareness and building plug-and-play media networks.
MSP is a software capability running on selected Cisco routers and switches that can learn information about media devices connected to them. For endpoints that use the standard signaling protocols supported by MSP, no change should be required on the endpoint side. Once the device and flows coming from endpoints are identified, MSP provides a platform for the user to enforce policies in the network that are aligned to business priorities in a logical and intuitive manner.
MSP uses lightweight packet inspection techniques on standards-based signaling protocols and produces flow metadata attributes that can be shared among network nodes. It uses a variety of standard signaling protocols (SDP, SIP, H.323, H.245, RTSP, mDNS, etc.) to learn about the characteristics of endpoints and applications from legacy systems and 3rd party endpoints, allowing sharing of flow attributes amongst network nodes. The information learnt can be seamlessly integrated with various other services in the network like bandwidth reservation for flows, differential treatment for these flows along the network, and easy deployment of end points in the network.
Seamless endpoint integration with the pervasive Cisco network that benefits a wide installed base without endpoint upgrades or additional development
Ability to prioritize traffic based on business policies for optimal quality
Reduced integration and deployment costs
Easy deployment and management of video endpoints, which mitigates admin complexities: one of the key current challenges in surveillance and conferencing space
Hi all.I have a cisco 1921 router with the following interface configuration. interface Embedded-Service-Engine0/0no ip addressshutdown!interface GigabitEthernet0/0description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$ip address 10.139.1.25 255...
I am configuring configuring circuit over DWDM NCS 2006 network.I created all internal and network patch cords as expected, but I keep receiving message A valid route cannot be found for circuit creation request. Any idea?
Hi all, How do i select the IOS in flash amongst the three in Cisco Catalyst 4948E Switch. I have set the boot flash of that particular IOS but whenever switch restart it loads the 1st one in auto. Kindly help in changing the priority of IOS / Flash ...
ear All, I wanted to check latency of Nexus 93180YC-FX as per data sheet it says latency is 1 microsecond. Our requirement is to reduce to the same to nano second is there any license available for the same? where we can install t...
I have an ISR 4451 running ios 15.5(2)S1c. It has a number of eBGP peers which have been working fine for ages. Ive added a new BGP peer simply viarouter bgp <my-as> bgp log-neighbor-changes neighbor 10.66.250.202 remote-as 120...