This document explains the solution for the error message %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface <interface> Power Controller reports power Imax error detected.
Power Imax / Tstart errors may be reported with some third party PDs.
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,Interface <interface>
Power Controller reports power Imax error detected.
Sep 21 22:25:13.675 GMT:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface Fa0/15: Power Controller reports power Imax error detected
You are hitting the bug CSCsw18530 : Power Imax / Tstart errors may be reported with some third party PDs
This error indicates that PD is drawing over-current more than allowed/supported per IEEE 802.3af standard. Seen with some of the 3750,3750G,3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C switches.
This issue is fixed in 12,2(55)SE3 , 12.2(58)SE1 and later releases. The following interface configuration commands have to be applied
to resolve the issue,
Switch(config)# int x/y
Switch(config-if)# power inline port 2x-mode
Switch(config-if)# no shut
The fix is present in the following platforms only : 3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C.The other platforms
do not support 2X power mode and the workaround would be to use a longer cable.Possible workaround is using Longer cable (>50ft)
Hi, I have replaced the new SUP720 card in chassis c6509 but it was going to rommon mode again and again after selecting the right image . Kindly find the below error messages . *** System received a Software forced crash ***signal= 0x17, c...
My PI 3.5 installation has the latest Update 3 installed and I just wanted to install the latest Upgrade 3.5.1. This failed, because the /var was full (once again....).
I dug a little bit deeper and discovered that logrotate is not workin...
Hello Team,we have Cisco 9200-48 P series and we are having trouble with avaya IP phones. These IP phones are unable to get the IP address from DHCP server, but the same avaya phone is working fine on Cisco 2960 series switches.Please suggest. Also please...
We've got C6807-XL with only two module slots occupied. Planning to expand network by populating two more slots. Can someone please confirm if this switch model is currently supported by Cisco and is not at the end of product life cycle, in which case we ...