This document explains the solution for the error message %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface <interface> Power Controller reports power Imax error detected.
Power Imax / Tstart errors may be reported with some third party PDs.
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,Interface <interface>
Power Controller reports power Imax error detected.
Sep 21 22:25:13.675 GMT:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface Fa0/15: Power Controller reports power Imax error detected
You are hitting the bug CSCsw18530 : Power Imax / Tstart errors may be reported with some third party PDs
This error indicates that PD is drawing over-current more than allowed/supported per IEEE 802.3af standard. Seen with some of the 3750,3750G,3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C switches.
This issue is fixed in 12,2(55)SE3 , 12.2(58)SE1 and later releases. The following interface configuration commands have to be applied
to resolve the issue,
Switch(config)# int x/y
Switch(config-if)# power inline port 2x-mode
Switch(config-if)# no shut
The fix is present in the following platforms only : 3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C.The other platforms
do not support 2X power mode and the workaround would be to use a longer cable.Possible workaround is using Longer cable (>50ft)
So for my lab, the ospf state remains INIT/DROTHER when doing "show ip ospf neighbor" on the router and shows nothing at all on the ASA. I am not sure what is configured wrong. Here are the applicable configs and that is basically any more complex co...
I'm setting up 2 ASA's in failover mode (active and passive) g0/0 is my wan (public IP)g0/1 is my lan (local IP)g0/5 is the lan failover (local IP) Do I need a secondary IP on all of those interfaces or just on the lan failover? Also ...
Hello,I am working on setting up some Policy based routing on my router. I need the subnet 172.16.208.0/24 to use 172.16.208.22 as the default gateway for traffic destined only to subnet 172.16.20.0/22. Traffic from 172.16.208.0/24 to anywhere else can us...
ello,We have a Cisco 1921 with the below configuration. We are testing our AT&T cell card in the MC7354 modem. It's up and running great at the moment. We are using an ikev2 VPN back to our datacenter. The only service on this router is the AT&T s...
Issue with Internet, currently using a Cisco router 881W to connect to WAN. Have limited to no internet for a week now. Router connected to Spectrum Cable modem. Have a pack of 5 Static IP addresses from Spectrum. We have had no issues for +3 years ...