This document explains the solution for the error message %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface <interface> Power Controller reports power Imax error detected.
Power Imax / Tstart errors may be reported with some third party PDs.
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,Interface <interface>
Power Controller reports power Imax error detected.
Sep 21 22:25:13.675 GMT:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface Fa0/15: Power Controller reports power Imax error detected
You are hitting the bug CSCsw18530 : Power Imax / Tstart errors may be reported with some third party PDs
This error indicates that PD is drawing over-current more than allowed/supported per IEEE 802.3af standard. Seen with some of the 3750,3750G,3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C switches.
This issue is fixed in 12,2(55)SE3 , 12.2(58)SE1 and later releases. The following interface configuration commands have to be applied
to resolve the issue,
Switch(config)# int x/y
Switch(config-if)# power inline port 2x-mode
Switch(config-if)# no shut
The fix is present in the following platforms only : 3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C.The other platforms
do not support 2X power mode and the workaround would be to use a longer cable.Possible workaround is using Longer cable (>50ft)
qosWe have voice traffic that we are identifying and marking using an ACL ip access-list extended voicepermit udp any range 16384 17683 any range 16384 17683 Then mark the traffic below with a DSCP of EFqos, qos testing, Routing Protocols, 291po...
Hi, How can I look at this policer real time values? ASR1001-X#show platform hardware qfp active feature subscriber session id 1426278251 feature policing
Policing Session Info:
Policing Ingress Config:
I am very new to telephony troubleshooting. We are having call quality issues. Here is a sampling from my logging and my the controller that seems to be resetting. Any thoughts would be great. T1-GWY-2921#sh controller T1 0/0/1T1 0/0/1 is up.Ap...
Hi all,Quick question about prefix lists. I'm peering with a partner and injecting a route map IN (BGP), which restricts the prefixes advertised to us, but a quick question, because I'm trying to save the amount of config to be written up. The partner is ...