This document explains the solution for the error message %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface <interface> Power Controller reports power Imax error detected.
Power Imax / Tstart errors may be reported with some third party PDs.
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,Interface <interface>
Power Controller reports power Imax error detected.
Sep 21 22:25:13.675 GMT:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface Fa0/15: Power Controller reports power Imax error detected
You are hitting the bug CSCsw18530 : Power Imax / Tstart errors may be reported with some third party PDs
This error indicates that PD is drawing over-current more than allowed/supported per IEEE 802.3af standard. Seen with some of the 3750,3750G,3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C switches.
This issue is fixed in 12,2(55)SE3 , 12.2(58)SE1 and later releases. The following interface configuration commands have to be applied
to resolve the issue,
Switch(config)# int x/y
Switch(config-if)# power inline port 2x-mode
Switch(config-if)# no shut
The fix is present in the following platforms only : 3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C.The other platforms
do not support 2X power mode and the workaround would be to use a longer cable.Possible workaround is using Longer cable (>50ft)
Hello. Have a new ASAv install using Anyconnect SSL VPN. Running 9.12(1), Device Mngr 7.12(1).VPN aaa-server is successfully authenticated too but the license will not register.Cet the REGISTRATION IN PROGRESS msg when checking sh license status.&nbs...
Im really confused about something At home I have a Cisco modem card that supports VDSL 2 which my ISP coming in is a service that supplies it IP addresses through PPPOE and they can change the addresses from time to time how do i do my NAT to allow multi...
Hi All, A dell 240 server is connected on two different switch ports with proper vlan configurations on the switch end. The server vendor claims to have put a static ip address without gateway on both these ports and the ip's do match the subnet...
Hi All, We've got an on premises server installed on our core switch (Stacked).When I tested it on a different rack switch (single), the slave was joining to the bond0 (Excuse my knowledge with the server configuration as I don't really know much abo...
I am planning on rebooting both the supervisor sup2T modules in our 6509E core switch. I want to do this with little to no downtime. My supervisor modules are running 15.1(2)SY2 software on both. the redundancy are configured to use SSO....