This document explains the solution for the error message %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface <interface> Power Controller reports power Imax error detected.
Power Imax / Tstart errors may be reported with some third party PDs.
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,Interface <interface>
Power Controller reports power Imax error detected.
Sep 21 22:25:13.675 GMT:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error,
Interface Fa0/15: Power Controller reports power Imax error detected
You are hitting the bug CSCsw18530 : Power Imax / Tstart errors may be reported with some third party PDs
This error indicates that PD is drawing over-current more than allowed/supported per IEEE 802.3af standard. Seen with some of the 3750,3750G,3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C switches.
This issue is fixed in 12,2(55)SE3 , 12.2(58)SE1 and later releases. The following interface configuration commands have to be applied
to resolve the issue,
Switch(config)# int x/y
Switch(config-if)# power inline port 2x-mode
Switch(config-if)# no shut
The fix is present in the following platforms only : 3750-E,3560-E, 3750-X, 3560-X, 3560-C, 2960S, 2960,2960C.The other platforms
do not support 2X power mode and the workaround would be to use a longer cable.Possible workaround is using Longer cable (>50ft)
Hi the community, I would like to have your point of view and suggestion about my problem. As you can see on the draw attached, I have static routing and dynamic routing for the same remote sites LANs.My goal is to replace the static routing by ...
We have a ISR4351-V/K9 as a voice gateway with all licensed pack included. For High Availability feature, we need another ISR4351-V/K9 router.So my question is, do we need to buy the hardware part with all license pack like existing one or just need to pu...
Hi Cisco press book says if we delete the VLAN all ports assigned to that VLAN fall back to default VLAN and port still remain up As per my test port is not changing to VLAN 1 when I delete the VLAN.instead, I see that VLAN is inactive. and stau...