THREE PART SERIES This Deep-Dive series is focused on the advantages of Nexus 1000v Solution across spectrum of technologies and how it can be leveraged to enhance your Data Center Virtual Infrastructure to meet the next-generation goals.
Cisco Nexus 1000V Series Switches provide a comprehensive and extensible architectural platform for virtual machine (VM) and cloud networking. The switches are designed to accelerate server virtualization and multitenant cloud deployments in a secure and operationally transparent manner.
From single hypervisor to now a multi-hypervisor virtual networking solution, Cisco Nexus 1000v has come a long way since its launch few years back. Currently 1000v product-line provides complete solution ranging from Switching, Routing, Firewall, Load-balancing to Cloud-Infrastructure.
Vishal Mehta is a Technical Marketing Engineer with Cisco's Data Center Competitive Insights Team based in San Jose, California. Previously he was working as the customer support engineer for Cisco’s Data Center Server Virtualization Technical Assistance Center (TAC) team for the past 3 years with a primary focus on data center technologies such as Cisco Nexus® 5000, Cisco UCS, Cisco Nexus 1000V, and virtualization. He presented at Cisco Live in Orlando 2013, Milan 2014, and San Francisco 2014 (BRKCOM-3003, BRKDCT-3444, and LABDCT-2333). He holds a master’s degree from Rutgers University in Electrical and Computer Engineering and has CCIE® certification (# 37139) in Routing/Switching, Service Provider & Data Center
Ask your Questions in the Discussion forums from February 12 through March 4, 2015
Hi; I've configured Xconnect over MPLS Cloud between 2 sites Xconnect is showing up but there is no reach-ability between the 2 sites from LAN your help R1 (ISR 4321)pseudowire-class R1encapsulation l2tpv3ip local interface Loopback100inter...
i have switches already configured with snmpv3 and i need to move the configuration to other switches and have some understanding of the commands: 1-does "access snmplist" is an access-list that points to the server which is using the snmp like solar...
Is it possible to configure a group on ports in an untagged VLAN to pass 802.1x authentication between themselves? For example, a device in VLAN 99 on port 10 perform 802.1x authentication with a device in VLAN 99 in port 11?
What does below error indicate ? Currently all modules diagnostics is showing passed. WS-C6509-E VS-SUP2T-10G In VSS15.1(2)SY10 r2d2_test_one_scratch_reg16:test faile reg[0x0]r2d2_test_one_scratch_reg16:test faile reg[0x1]r2d2_test_one_scratch_r...
Hi all,I am using my core switch cisco 4500E as NTP server for CUCM servers . the core switch sync its time with WAN firewall by stratum 6 which makes the core switch as stratum 7 for CUCM servers and this is not accepted.how to make the core switch...