If you suspect a fan failure, perform these steps:
Check the LEDs. If all the LEDs are off, check the power to the switch. The fan could have failed due to a power problem.
Check the system LED. If it is amber, the system has detected a problem. If you cannot hear the fan operating, this could indicate a fan problem.
Note: If you are using a Catalyst 3524-PWR-XL, 2940, 2950 and 2955, 2970, 3550 or 3750 series switch, check the fan for failure by issuing the show environment fan command, as shown in this sample output:
We tried to insert a new stack member - the primary - into a stack. I wasn't there to see the precise order cabling and power on. Butmy understanding is that racking the replacement primarystack member and cabling it up as the previous primary s...
Greetings - I ordered 1GB Ethernet DIA for three different sites. Each site was delivered with a fiber handoff, instead of an Ethernet handoff. Now the carrier is wanting to charge extra for the media converter for each site. W...
Hello , I use this command to set Preference = LTE .cellular 0/2/0 lte technology lteAfter this command it change to LTE . cisco_1117#show cellular 0/2/0 radio
Radio power mode = online
LTE Rx Channel Number = 550
LTE Tx Channel Numb...
Ive tried to configure Dhcp on my Lan A computer by it keeps on failing can someone walk me through on what I should doRouter(config)#ip dhcp pool LanARouter(dhcp-config)#network 18.104.22.168 255.255.255.0Router(dhcp-config)#default-router 22.214.171.124Router(dhcp-c...
Hello I know I should know this... I was wondering how this works. My 1921 GE 0/0 has a 10.0.0.68 IP address from the Internet. The GE 0/1 is assigned 192.168.0.1 with a DHCP Server vlan 1. My 2960 is connected to the GE 0/1 and have it set...