I have a 2960G switch and I use the Express Setup mode to connect for the first time on the switch with Internet Explorer.
All goes well, I can connect my Laptop to the switch using 10.0.0.1 IP address (normal Ethernet cable), but a windows asks me a "user name and password" for level 15 access, when normally there is no password and username.
Hi. By default, Is there a "deny any" at the last line for all ACL? for ACL 2, will it allow all? access-list 1 permit 22.214.171.124 0.0.0.31access-list 1 deny anyaccess-list 2 permit 126.96.36.199 0.0.0.31Thanks!
Is anyone aware of a MIB to get interface switchport config via SNMP for a 2960 switch? In particular I"m looking to get whether or not the interface has switchport protected enabled. I'm looking around but haven't come across anything j...
Meet the Authors Event - Network Programmability with Joe Clarke
(Live event – Wednesday, May 21st, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Thursday 21st, May 2020 at 10hrs PDT
In this session,...
I am a very frustrated first time customer. This is my first time using Cisco equipment,and I didn't expect the technical phone support to be non-existent. In my twentyyears of buying from various manufacturers and dealing with their technical support Iha...