If you have recently bought a Cisco router to use on CenturyLink, you are in luck.
My name is Trevor, I have bought a Cisco 1841 to use on my internet. In order to get it to work on my network; I had to configure a port to use DHCP and get an address from my ISP. I then had to configure NAT to route the network to that port that has DHCP.
COMMANDS FOR THOSE WHO ARE NEW TO THE IOS:
int <WAN port here>
ip address dhcp
ip nat outside
int <LAN port here>
ip address <ip address here>
ip nat inside
ip nat inside source list 1 interface <port here> overload
If you have managed to get it to work, then you need to worry about port forwarding your XBOX or PS4 if you have those, otherwise you could end here.
Hi Guys,I'm pretty new on the VRF thing but i do think i understand the basics of VRF. We just got a new customer, which we place in a seperate VRF. Now the customers machines will need access to the internet. We have 1 internet connection. What is the be...
Cisco Application Hosting on Catalyst 9000 series of switches extends the cloud to the edge of the network enabling data processing closer to the critical source in a distributed manner. Application Hosting is used by various businesses and developers to ...
Hi ,i have a dynamic nat configured on our core switch ( 6807XL) . i configured more than 15 pool and 14 standard access list and one extended access-list , yesterday one of these pool ( which using extended access-list ) stopped working , till i us...
Hi Guys, I am getting the following error while creating the trunk link between 3650 48 ps to 3560cx-12 ps switch %PHY-4-SFP_NOT_SUPPORTED: The SFP in Gi0/11 is not supported Have tried the commands but no luck, any suggestions ...