These guidelines apply to auxiliary VLAN configuration:
An auxiliary VLAN port is operationally a trunk, even though it is not treated like a normal trunk port.
When an auxiliary VLAN is added to a port and the set dot1q-all-tagged command is enabled, the set dot1q-all-tagged command tags the native VLAN on the port where the auxiliary VLAN is configured. A port with an auxiliary VLAN configured is not viewed as a dot1q trunk in the show trunk command output, but the port acts like a dot1q trunk if the set dot1q-all-tagged command is enabled.
The IP phone and a device attached to the phone are in the same VLAN and must be in the same IP subnet:
If they use the same frame type
If the phone uses 802.1p frames and the device uses untagged frames
If the phone uses untagged frames and the device uses 802.1p frames
If the phone uses 802.1Q frames and the auxiliary VLAN equals the native VLAN
The IP phone and a device attached to the phone cannot communicate if they are in the same VLAN and subnet, but use different frame types. This is because traffic between devices in the same subnet is not routed (routing eliminates the frame type difference).
Switch commands cannot be used to configure the frame type used by traffic received from a device attached to the phone access port.
With software releases 6.2(1) and later, dynamic ports can belong to two VLANs, a native VLAN and an auxiliary VLAN.
Hello everyone, I understand STP and Etherchannel. I understand why STP is used i.e. to avoid broadcast storms i.e. switching loops by blocking certain ports, and etherchannel is used so that all the links bundled in an etherchannel appear as one logical ...
I am trying to setup a site to site vpn to 2 remote sites where the remote sites have MIFI. if I use the RV160w at the remote sites, is there an issue to leverage the address from the wireless MIFI to bind the tunnel to back to the RV160 in the main...
Hi everybody! I've some question about inter-AS VPN option AB(D)in article Inter-AS Option AB says "By default, ASBR1 does not advertise the source prefix RD 2:N to ASBR2. This advertisement is suppressed as the prefix is being imported into an...