A Permanent Virtual Circuit (PVC) is a circuit that a network operator manually provisions over an Asynchronous Transfer Mode (ATM) switched network between a specific source and a specific destination.
Multipoint bridging (MPB) enables point-to-multipoint bridging for ATM PVCs and Frame Relay data-link connection identifiers (DLCIs). This feature allows the use of multiple VCs or DLCIs for each VLAN for bridging on the Enhanced FlexWAN module.
Bridged PVCs have the 802.1 header (0xAA-AA-03) and several other fields that include a metropolitan-area network destination address.
In order to support the multiple VC feature, the switch must run Cisco IOS 12.2(18)SXE or later, which can be downloaded from the Cisco Downloads.
Note: It is also necessary to enable Bridge Protocol Data Unit (BPDU) translation with the bridge-domain[vlan id] access command.
Dear, Thanks in advance.I want to increase the latency of a sub-interface p2p IP and other services running through this VLAN. Example: Sub interface VLAN ID: 100 ( Te0/1/0/1.100)Current Usage: 100MbCurrent latency 1ms at p2p and other serv...
I'm attempting to set up dot1x authentication on a 3650 switch (just one port for now). I'm using NPS as my RADIUS server. I'm looking for help figuring out what this Missing Config mentioned in the debug is referring to. The debug on the ...
Using show crypto ipsec sa we can get SPI, transform algorithms and etc, but it doesn't show ESP encryption keys.Is there is a way to get it?For instance, FortiGate has diagnose VPN tunnel list command which allows it.
Hi, I have a router connected to a FW via a subinterface. I have source nat configured in the router so I offered the natted addres to the FW for some traffic coming from the Wan. In the FW the customer don't want to have an static route pointin...
hello i have website which use my local server services and nat works but this services do not work on local i can not connect to my local outside interface from inside is it nat problem or anything else?