To upgrade Cisco IOS Software or enable new features, memory requirements must be met.
To determine the amount of Flash and DRAM, issue the show version command. Refer to the bold text in the output below. DRAM is divided logically, combining the two numbers to determine total DRAM. In this case, it is 45056K/4096K bytes (45056kB + 4096kB = 49152kB), which is equal to 48MB.
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-JS56I-M), Version 12.1(5)T9, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Sun 24-Jun-01 15:29 by cmong
Image text-base: 0x80008088, data-base: 0x8149F218
ROM: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
R1 uptime is 9 weeks, 3 days, 2 hours, 32 minutes
System returned to ROM by power-on
System image file is "flash:c2600-js56i-mz.121-5.T9.bin"
cisco 2651 (MPC860P) processor (revision 0x200) with 45056K/4096K bytes of memory.
Processor board ID JAB04390J7N (1507969529)
M860P processor: part number 5, mask 1
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
You can also see memory information using following commands:
Working on a stack of new Catalyst 9200L-24P-4G switches. This is the first time with this model and am beyond frustrated at this point as none of the documentation seems to work. Currently, all 4: Switch Ports Model SW Version ...
Hi, I can't find SNMP OID for cisco 3850 stack status. To be honest I can't find any IOD's. Because SNMP WALK gives me range .1.0.8802.1.1.2.....But snmp navigator does not know this OID's. How can I determine what each oid means?
Dear , I am facing an issue with connectivity for ipsec vpn with fortigatesee below sh run crypto isakmp policy 10hash md5authentication pre-sharegroup 2crypto isakmp key xxxx address xxxxx!!crypto ipsec transform-set MYSET esp-des esp-md5-hmacm...
Hello CISCO Community. I have an idea but I am not sure if I am just limited in the IOS to make this work or if there are any other technologies / configurations to make it happen. Basically, I am connecting two switches together with 2 links a...