To upgrade Cisco IOS Software or enable new features, memory requirements must be met.
To determine the amount of Flash and DRAM, issue the show version command. Refer to the bold text in the output below. DRAM is divided logically, combining the two numbers to determine total DRAM. In this case, it is 45056K/4096K bytes (45056kB + 4096kB = 49152kB), which is equal to 48MB.
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-JS56I-M), Version 12.1(5)T9, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Sun 24-Jun-01 15:29 by cmong
Image text-base: 0x80008088, data-base: 0x8149F218
ROM: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
R1 uptime is 9 weeks, 3 days, 2 hours, 32 minutes
System returned to ROM by power-on
System image file is "flash:c2600-js56i-mz.121-5.T9.bin"
cisco 2651 (MPC860P) processor (revision 0x200) with 45056K/4096K bytes of memory.
Processor board ID JAB04390J7N (1507969529)
M860P processor: part number 5, mask 1
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
You can also see memory information using following commands:
We are designing a SDA setup with 9300 as edge nodes.and 9500 as border node. My question in regards to DNA licensing:- Do we need to buy DNA premier and separate license for ISE appliance ?- We tried to generate BoM using Cisco CCW portal and ...
Request to help us in exporting output of customized CLI templates in presentable format either in excel or PDF as soon as we deploy on the added network devices under prime infrastructure 3.4 tool.If we are more precise we have couple of devices added un...
Hi, In order to get a 10G uplink speed between my new Cisco C9200L-48P-4G-E switch I thinking to buy and the Core switch (C9407), Does the C9200L-48P-4G-E support C9200-NM-4X (10G uplink network module) ? Thanks in advance. H...
Hello, I have a cisco 2960 and I'm trying to set up QoS on it for my Voip Traffic. We are using a Voip softphone software as our voip device. I have enabled the command "mls qos trust dscp" on the access ports going to the softphones, however w...
I am facing an unusual issue with my cisco 2960s switches configured as port-security as MAC-STICKY.All the campus access layer switches connected over a distribution switch(Huwei 66XX series) are experiencing continuous mac-address violation in huge numb...