The new Cisco Catalyst Express 500 Series switches provide smart, simple, and secure networking for customers with up to 250 employees. This new series of Layer 2-managed Fast Ethernet and Gigabit Ethernet switches offers nonblocking, wire-speed performance. This provides a secure network foundation optimized for data, wireless, and IP communications.
There is no Command Line Interface (CLI) on the Cisco Catalyst Express 500 Series switches. These switches are managed either through the embedded device manager, with the Cisco Network Assistant, or with Simple Network Management Protocol (SNMP) management applications.
The Cisco Catalyst Express 500 Series switches have this range of products:
Cisco Catalyst Express 500-24TT: Part Number: WS-CE500-24TT
Cisco Catalyst Express 500-24LC: Part Number: WS-CE500-24LC
Cisco Catalyst Express 500-24PC: Part Number: WS-CE500-24PC
Cisco Catalyst Express 500G-12TC: Part Number: WS-CE500G-12TC
Software for these fixed configuration switches is available from Software Downloads. A CCO account is required to view this page.
From the Software Downloads page, perform these steps to download the appropriate software:
Click on Switch Software.
Click on LAN Switches.
Click on Cisco Catalyst Express 500 Series Switches and then on the Cisco Catalyst Express switch on which you want to upgrade the Cisco IOS .
Once the new Cisco IOS version is downloaded, perform these steps to update the switch:
Open up the switch management GUI.
Click on Software Upgrade.
On the Software Upgrade screen, click on Browse and select the tar file downloaded from the Cisco web site.
Click on Upgrade.
Note: Wait for the upgrade process to complete. Do not use or close the browser session with the device manager, and do not access the device manager from another browser session.
When the upgrade process completes, a success message appears, and the switch automatically restarts. It can take a few minutes for the switch to restart with the new software. Verify that the latest software version on the switch appears in the Software field in the Switch Information area of the dashboard.
HI everyone, We are occuring a issue that is snmp read the Catalyst4500X swtich power supply status normal, but the real status of power supply 2 is "bad/off". So what wrong with this symptom ？Is it a bug ? Some information of this issue:1...
We are thinking about to connect all Cluster ports to one LAN switch. As stated in HA guide 22.214.171.124 an appliance port / Cluster Port failure can be recovered by the cluster. What will happen in our case, when the LAN switch will fail and a...
Hi all, I am facing issue with FTTH pppoe connectivity, i have two connectivty with my location.The primary link is BSNL leased line and secondary link is FTTH pppoe with bridge mode.I have created ipsec site to site vpn to reaching to my DC, i am no...
Hello floks,In my setup, i use Mgmt-vrf for system management. When the management interface gets dieconnected, the global vrf should be used. The config is as below. Switch-3850#sh run vrf
vrf definition Mgmt-vrf!address-family ipv4route-replicate f...
Morning from London, I'm not entirely sure where to post this, so correct me if I've posted in the wrong place. I'm thinking about starting my CCNP studies. I bought the 3 books while studying for my CCNA, however, the exams are changing i...