Linecards reset, and the "%PM_SCP-SP-1-LCP_FW_ERR", "%OIR-SP-3-PWRCYCLE" and "%C6KPWR-SP-4-DISABLED" error messages are displayed in the logs of a Cisco Catalyst 6500 switch that runs Cisco IOS system software
Cisco Catalyst 65xx series switches can reset with the %PM_SCP-SP-1-LCP_FW_ERR, %OIR-SP-3-PWRCYCLE and %C6KPWR-SP-4-DISABLED error messages. This problem affects Cisco IOS Software Releases 12.2(17d)SXB9 and 12.2(17d)SXB10.
These are the descriptions of the error messages:
PM_SCP-SP-1-LCP_FW_ERR: System resetting module [dec] to recover from error This message appears when the firmware of the specified module detects an error. The system automatically resets the module to recover from the error.
OIR-SP-3-PWRCYCLE: Card in module [dec], is being power-cycled off This message indicates that the module experiences a port Application-Specific Integrated Circuit (ASIC) error.
%C6KPWR-SP-4-DISABLED: power to module in slot [dec] set off This message indicates that the module experiences a Port ASIC error.
For more information, refer to Cisco bug ID CSCej52641.
To resolve this problem, upgrade Cisco IOS Software to Release 12.2(17d)SXB11 or later.
Hi I am not a network person, please answer me like I am a three year old.I have a WS-C2960-8TC-S; (actually the case says "Si") SN: FOC1529V12A. I would like to purchase a SFP Transceiver so I can send it a FO signal. 1) Which ...
Hi there, thanks for reading. I need to replace an SG220. I'm seeing that the show run leaves out commands that are viewable via the http GUI. Is there a way to capture ALL of the running config? The GUI backup procedure just grabs...
So I'm attempting to configure a loopback address on my Cisco cat-3850 Switch to be pingable on a host PC. The devices are already connected via an Ethernet cord and despite the fact that, if the Switch goes through to the Router, it can reach the in...
Hello, I am trying to setup SNMP v3 on our Catalyst 2960 switches.I got the configuration setup and it`s working. But I noticed SNMP information can be pulled from other NMS if correct credentials are provided. Below is my SNMP config on Catalys...
Configuration: We have a carrier-ethernet network consisting of 5 core routers at different locations. Each core router has two bridge domains configured: BD 10 for management and routing, and BD 20 for layer 2 transport of user data.&nb...