I was wandering if anyone came across the same TCP traffic behaviour. There are about 30 sites in Europe. There are 3000 people working on thoses sites. All are connected through a cisco router to the MPLS network. The configuration of all routers is one standard configurations
When ping from PC
C:\>ping www.google.com -l 1500 -f Pinging www.l.google.com [188.8.131.52] with 1500 bytes of data: Packet needs to be fragmented but DF set. Packet needs to be fragmented but DF set. Packet needs to be fragmented but DF set. Packet needs to be fragmented but DF set.
Ping statistics for 184.108.40.206: Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
Pinging www.l.google.com [220.127.116.11] with 1400 bytes of data: Reply from 18.104.22.168: bytes=64 (sent 1400) time=45ms TTL=47 Reply from 22.214.171.124: bytes=64 (sent 1400) time=53ms TTL=47 Reply from 126.96.36.199: bytes=64 (sent 1400) time=44ms TTL=47 Reply from 188.8.131.52: bytes=64 (sent 1400) time=46ms TTL=47
Ping statistics for 184.108.40.206: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 44ms, Maximum = 53ms, Average = 47ms
Router cisco Cisco IOS Software, 3800 Software (C3845-ADVIPSERVICESK9-M), Version 12.4(15)T6,
Have made a test with ISP they can not ping lan with df set size 1500,but it is susseful with 1400 before evey think as working fine till l get this error in my router %C3800_ENVM-3-MFAIL_OFF : There is more than one failure with the Power System [dec] or this Power System has been turned off. since than users cannot browse from internet
I have filtered my packet captures on specific TCP conversation and after downloading it into Wireshark There are some lost packets which are followed by 'TCP previous segment lost packets' (TCP packet arrives with a sequence number greater than the "next expected sequence number') however they are never retransmitted. The peer doesn't send either TCP duplicated ACKs requesting retransmission of the lost packets. I believed that in TCP connection needs to ACK every single packets and lost packet will always be retransmitted. Could anyone please advise.
Hello everybody, I have recently encountered with some issues on my c9300-48P-A, c9300-48T-A switches with 16.12.04 IOS. I configure interfaces by these commands: interface GigabitEthernet1/0/1authentication event fail action authorize vlan...
Hi All, We have a Centrally location connected to 10 remote locations via Two different MPLS connections. At present it is Active + Standby, Please could you Suggest ways to implement Active + Active Central location have 2 separ...
Hi All,I am using packet tracer and am simply trying to enable some standard ACL's on the switches.I am wanting to follow the Deny all principle then permit what is necessary. I wish for the following to communicate:CORP Client - Internet AccessCORP ...
Hello everyone, A Non-Cisco 24 ort Switch is connected on my Cisco Catalyst Switch port. I want to see all the MAC addresses connected on Cisco Switch port in Descending order. I am running the following command with INCLUDE but it does't help : ...
Hi, I've recently upgraded a POE switch from a SF-300-48P to a WS-C2960X-24PS-L.I have 4 Ruckus APs connected to the POE switch with corporate WiFi on vlan 1 and guest WiFi on vlan 10. On the SF-300 both WiFi networks work. After moving the APs ...