The Cisco Catalyst 6500 Series Communications Media Module can support single or multiple Cisco CallManagers in a voice-over-IP network. The Communications Media Module, which acts as the media gateway, uses the Media Gateway Control Protocol (MGCP) to communicate with Cisco CallManager, which acts as the media gateway controller (Call Agent).
The Communications Media Module accepts either a 6-port T1 interface module or a 6-port E1 interface module. You must use the same types of interface modules (either all T1 modules or all E1 modules) in the Communications Media Module; you cannot mix the interface module types.
The 6-port T1/E1 interface modules have onboard digital signal processor (DSP) resources that allow you to connect the interfaces to the public switched telephone network (PSTN) or private branch exchanges (PBXs) through T1 Channel Associated Signaling (CAS) or T1/E1 ISDN Primary Rate Interface (PRI). The DSP resources on the interface modules provide echo cancellation, transcoding, fax relay, tone detection and generation, and jitter buffers.
The WS-SVC-CMM-6T1 module requires a minimum CatOS version 7.6(12) and a recommended version of 8.3(3).
I tried to use "secret 0" followed by an unencrypted secret. But then when I tried to access the device the password is not being accepted. In the example below - should not the password foruser skipper be foo123? username skipper pri...
Hi,I have the SG350X with inter-VLAN routing disabled. It is trunked to another switch that works as the router. No static routes are defined on the SG350X since I would like it to behave like an L2 VLAN aware SwitchWhen I try to access VLAN 1 management ...
Hello all,I am having an issue to which I have not really be able to find a cause or resolution. The OSPF neighbor relationship between 2 routers keeps dropping, then immediately reforming the adjacency.ROUTER1GW#May 13 13:35:51 EDT: %OSPF-5-ADJCHG: Proce...
Hello, I am wondering about the following scenario and if it falls under a best practice. Two locations and each location is identical in terms of equipment and purpose. Let's say location A had a vlan 100 with 184.108.40.206/24 would location B best be ...
Hello Team,I have two vEdge virtual routers in Azure and I need a server that's behind them to be publicly available. Has anyone config'd this yet? I think I have a good understanding of what I need to do but figured to throw this out there.