This script implements multiple pipe support from the IOS command line.
Script Modified Date:
Aug 17, 2010
Cisco IOS Version tested:
Cisco Products Tested:
Environment Variables used:
Script Info URL:
How many times have you wanted to do "show run | inc snmp | redirect flash:/snmp.cfg"? Up until now this wasn't possible because IOS only supports one pipe. The other pipes are treated as part of the argument to the first pipe command. The cl_multi_pipe.tcl EEM policy enables the support for multiple command pipelines. You can run as many pipe commands as you want.
I am having a problem with the 2504 WLC in packet tracer 7.2.2.0418. The issue is once I finish the initial setup and the wlc reboots, it never comes back up. I can't ping it, or connect via web address. I have verified connectivity befo...
Hello, I am using router ISR C1111 8p. I have option to make port-channel and assign IP to it, but when i have to configure channel group on interfaces i am not able to run command "Channel-group 1 mode active". error message Unrecognized command.kin...
Hello Tech People,I am new to this forum and not a cisco expert either but would appreciate some experts help please. I have configured VLAN's in my home network, mainly to separate IoT devices from other devices.A bit about my network1. Untangle Edg...
I've got a Catalyst 9300 24T that had been setup to route a set of IP address ranges out a different interface based on a PBR match list. Twice in the last 10 days I've had it stop processing the route-map around 2am. We don't have any re...
I have the following topology set on AWS where there are 4 CSR 1000v Routers deployed and Segment Routing enabled in which the Segment Routing Headend is R1 and the destination is R3. I aim to send perf traffic from Endpoint1(Client) t...