The problem is between management interface Nexus 2248 and MDS9148, sometimes there is connection lost between this interfaces. To solve the problem immedialtly, it's necessary to put a PC or reboot Nexus2248. Then if you wait a moment the connexion back again. In attachment, the IOS version :
sh ver Cisco Nexus Operating System (NX-OS) Software TAC support: http://www.cisco.com/tac Copyright (c) 2002-2010, Cisco Systems, Inc. All rights reserved. The copyrights to certain works contained herein are owned by other third parties and are used and distributed under license. Some parts of this software are covered under the GNU Public License. A copy of the license is available at http://www.gnu.org/licenses/gpl.html.
Software BIOS: version 1.3.0 loader: version N/A kickstart: version 5.0(2)N1(1) system: version 5.0(2)N1(1) power-seq: version v1.2 BIOS compile time: 09/08/09 kickstart image file is: bootflash:/n5000-uk9-kickstart.5.0.2.N1.1.bin kickstart compile time: 10/15/2010 0:00:00 [10/15/2010 10:00:43] system image file is: bootflash:/n5000-uk18.104.22.168.N1.1.bin system compile time: 10/15/2010 0:00:00 [10/15/2010 11:34:05]
Hardware cisco Nexus5010 Chassis ("20x10GE/Supervisor") Intel(R) Celeron(R) M CPU with 2073416 kB of memory. Processor Board ID JAF1434BHBG
i am confused policing drops data that exceeds the set amount in bandwidth, and can resend data but shaping slows down data and can resend data ? I Was reading the Cisco cert guild can you apply shaping and policing on the queues?
Hi, I´m planning implement private vlan for all switches on network, 15 switches on all network ( there are 15 floors separetd by vlan 1-15). The purpose is block the hosts communicate each other on same network. I dont have ISE to implemment the bes...
Hi, I am trying to utilize DLEP with the EIGRP routing algorithm. If I query the system with "sh dlep neighbors," I see the correct CDR(Current Data Rate) for two radios connected with DLEP to the router, one having a data rate half of the other...
Hello everyone, I'm doing a review of some Cisco devices (switches and routers) and one of the questions I need to respond to is the date when the last patch was applied to the devices. Is there a way I can determine that from the equipment?
Hi there, I would like to use IP SLA UDP Jitter to alert when the MOS score is greater than 3.5. My config: ip sla 2udp-jitter 22.214.171.124 5000 codec g711alawtos 184threshold 60timeout 500frequency 15history hours-of-statistics-kept 1history en...