This document is editable by everyone. If you know of an OID, please add it. If one is incorrect, please correct it and add notes.
Monitoring CPU on Routers
Monitoring Memory on Routers
SSL Stats: 220.127.116.11.4.1.3076.2.2.26
IPSec Stats: 18.104.22.168.22.214.171.124.9.9.171
Remote Access Stats: 126.96.36.199.188.8.131.52.9.9.392
FIPS Stats: 184.108.40.206.220.127.116.11.9.9.999999
Active Connections in PIX/ASA Firewall: 18.104.22.168.22.214.171.124.126.96.36.199.188.8.131.52.7
The total number of currently active IPsec Phase-2 Tunnels: 184.108.40.206.220.127.116.11.18.104.22.168.1.0
You will need the following MIBs: IF-MIB, RFC1213-MIB, CISCO-MEMORY-POOLMIB, CISCO-PROCESS-MIB, ENTITY-MIB, CISCO-SMI, CISCO-FIREWALL-MIB, ASA also adds CISCO-IPSEC-FLOW-MONITOR-MIB, CISCO-FIPS-STAT-MIB, and ALTIGA-SSL-STATS-MIB.
Hi,I have 60m of OM2 fiber linking two 3750X equipped with 3CKX-10G-NM.I'm using SFP-10G-SR (in TE ports, not in GE ports).But I'm not getting connection between the two switches (No led blinking at all).Is there a compatibility problem somewhere in my sc...
Hi,I have looked into a couple of older forums which lists different MIBS and OID though which this can be achieved but all those are old OIDs which I cant get it to work on the newer Catalyst 9200L switch or 3650 series.We have a remote switch for which ...
I have a Cisco 2800 series router that no one knows the IP address of or the username and password to. It's not the gateway on the PC as it's pointed to a Cisco ASA, which I have full access to. I assume there's a setting in the ASA that point...
Is there such thing as DHCP inspection on IOSXE SDWAN routers? We are running asymmetric routing where the discover message goes out to MPLS and the offer goes back through SDWAN but the transaction ID gets messed up so the end host just keeps on sending ...
Hello all. I am beginner on cisco configuration and networking. I managed a labs network and should include a Cisco C1111-8p inside.My management is limited to a Firewall and different switch below.It 's seems that I have configure correctly the WAN ...