I have two locations: Corporate and Production
I need to send traffic from a PC on the Corp inside LAN with address, 192,168.100.20 to a destination of 192.168.101.1 On the Prod LAN on port 12123.
The path for this traffic is Corp LAN into a Cisco ASA then into a 2811 router, over frame Relay circuit to 2811 router in Production. The destination address of 101.1 if s the interface of the ASA in Prod directly connected to the 2811 router.
****The application sending the traffic is configured with a destination address of 172.168.25.30 NOT 192.168.101.1
Question:
How would I set up PBR on the Corp router to take this traffic to its next hop of 172.16.25.30 and reach the destination address of 192.168.101.1
I have attached a drawing for hopeful clarity
