Probable causes which trigger such issues with LACP port channels:
1. Adding a new port to an existing port channel. If any configuration mismatch is seen on the newly added port, it will be added to Secondary port-channel as you can see (Here, Po1A)
2. Configuration mismatch on the ports bundled in the port channel.
3. Configuration mismatch on the interfaces of the far end device can also create inconsistency between the ports bundled in the port channel.
'mls qos channel-consistency' is one of the reason which willput the port in to secondary port-channel.
The first step to resolve this issue is to look for the command "mls qos channel-consistency" in the interface configuration or to recreate the port channel following the best practices mentioned below
The best practices in resolving port channel issues are:
1.Manually shut the bundled interfaces and the port channel interface down on both the end.
2.Then reset the interface configuration to default.
3.Reconfigure the interfaces to be bundled and assign them to the port channel.
4.Verify the configuration of the interfaces.
5.Bring up the interfaces after the configuration has been verified.
This is a known and an expected behavior with LACP. If LACP is not a mandatory requirement, you may recreate the port channel with the channel mode "ON".
these routers are direclty connected via point to point connection. When I try summarization, only ip route x.x.x.x x.x.x.x null0 with network statement works for me. When I use the aggregate address command I dont see summary route in route t...
Hi,I have an ASA2110 for multiple VPN customer's which are accessing different servers in our cloud environment.I will make this as simple as I can, my scenario is like this: 1 - On the ASA there is a DMZ sub-interface configured on 192.168.56.0/24 s...
I try and read and help people on here, however....Surely there needs to be some sort of competence level before people are allowed to post?I see more and more posts that I just think FFS how have you even got a CCO account?My Cat 3850 won't route? Come o...
Hi, I am struggling with the setup of the WLC 9800 on a Catalyst 9300 Switch. I would like to configure it from DNA Center but I think DNA Center is not aware that I have one.Here is the output from my switch Next reload AIR license Level: AIR DNA Ad...
Hi all, I’ve been reading up and SPAN and the use of aggregator taps and full duplex taps. I feel i have a better understanding of each, but i still have a question that cannot seem find the answer to, hopefully somebody will know the answer to...