Provides the ability for a Cisco ISR, IR or CGR router to automatically return its cellular service to LTE if it has fallen to 3G or 2G (if LTE service is available). Without the applet, the router may remain on 3G even if LTE service is available. This is due to current LTE standards as implemented in LTE modems and networks.
•Automatically restores ISR Radio Access Technology (RAT) to 4G LTE if it has fallen to 3G or 2G
•This can temporarily occur due to weather conditions, interference, cellular network congestion
•Although LTE reselection is automatic, standards dictate that a device’s LTE modem be in idle mode to reselect (up to 15 seconds w/no traffic up or down). Easy for phones, not for routers
•This app can be set to run at any desired frequency and/or time-of-hour/day/week.
This version supports a single ISR cellular interface. Note that there is a cellular service disruption of ~15 seconds if in 2G/3G mode and the app attempts to restore 4G operation.
Requires one environment variable called timer and the value must be in form of crontab. Example to run the script everyday at midnight local time.
Hi; I've configured Xconnect over MPLS Cloud between 2 sites Xconnect is showing up but there is no reach-ability between the 2 sites from LAN your help R1 (ISR 4321)pseudowire-class R1encapsulation l2tpv3ip local interface Loopback100inter...
i have switches already configured with snmpv3 and i need to move the configuration to other switches and have some understanding of the commands: 1-does "access snmplist" is an access-list that points to the server which is using the snmp like solar...
Is it possible to configure a group on ports in an untagged VLAN to pass 802.1x authentication between themselves? For example, a device in VLAN 99 on port 10 perform 802.1x authentication with a device in VLAN 99 in port 11?
What does below error indicate ? Currently all modules diagnostics is showing passed. WS-C6509-E VS-SUP2T-10G In VSS15.1(2)SY10 r2d2_test_one_scratch_reg16:test faile reg[0x0]r2d2_test_one_scratch_reg16:test faile reg[0x1]r2d2_test_one_scratch_r...
Hi all,I am using my core switch cisco 4500E as NTP server for CUCM servers . the core switch sync its time with WAN firewall by stratum 6 which makes the core switch as stratum 7 for CUCM servers and this is not accepted.how to make the core switch...