Provides the ability for a Cisco ISR, IR or CGR router to automatically return its cellular service to LTE if it has fallen to 3G or 2G (if LTE service is available). Without the applet, the router may remain on 3G even if LTE service is available. This is due to current LTE standards as implemented in LTE modems and networks.
•Automatically restores ISR Radio Access Technology (RAT) to 4G LTE if it has fallen to 3G or 2G
•This can temporarily occur due to weather conditions, interference, cellular network congestion
•Although LTE reselection is automatic, standards dictate that a device’s LTE modem be in idle mode to reselect (up to 15 seconds w/no traffic up or down). Easy for phones, not for routers
•This app can be set to run at any desired frequency and/or time-of-hour/day/week.
This version supports a single ISR cellular interface. Note that there is a cellular service disruption of ~15 seconds if in 2G/3G mode and the app attempts to restore 4G operation.
Requires one environment variable called timer and the value must be in form of crontab. Example to run the script everyday at midnight local time.
I have two 5672UP Nexus switches setup as VPC peers, both running NX-OS 7.3(5)N1(1). I have enabled the peer-switch command and equal spanning tree priorities for all vlans that support the VPC members. I have also confirmed that a...
Can someone please help me? I don't seem to know why this router has two default routes in the running config. Please see below ro-1.gbr.amsterdam#show running-config | i ip routeip route 0.0.0.0 0.0.0.0 192.168.1.254 254ip route 0.0.0.0 ...
Hi there, i'm not able to ocnfigure "enable secret" or even "service password-encryption" commands on the cli of my SG350X switch. Is the CLI really so much cut-off or do i try to use obsolete commands?
Description: SVI stopped working in many switches of my inside network but some switches are still working fine. There is a difference of days and hours from 1 switch to other switche when SVI stopped. I tired all the possible solutions from blogs/google ...
Hi Guys, Any of you had any experience using AMP with the SD-WAN Solution? I've recently been entitled with a Threat Grid Account and since then I'm not able to configure any device that has the security policy with AMP configured. The erro...