Provides the ability for a Cisco ISR, IR or CGR router to automatically return its cellular service to LTE if it has fallen to 3G or 2G (if LTE service is available). Without the applet, the router may remain on 3G even if LTE service is available. This is due to current LTE standards as implemented in LTE modems and networks.
•Automatically restores ISR Radio Access Technology (RAT) to 4G LTE if it has fallen to 3G or 2G
•This can temporarily occur due to weather conditions, interference, cellular network congestion
•Although LTE reselection is automatic, standards dictate that a device’s LTE modem be in idle mode to reselect (up to 15 seconds w/no traffic up or down). Easy for phones, not for routers
•This app can be set to run at any desired frequency and/or time-of-hour/day/week.
This version supports a single ISR cellular interface. Note that there is a cellular service disruption of ~15 seconds if in 2G/3G mode and the app attempts to restore 4G operation.
Requires one environment variable called timer and the value must be in form of crontab. Example to run the script everyday at midnight local time.
Hi We have installed the GPRS card and Vodafone 2G SIM Card in the router. We have done the GPRS configuration but GPRS is not coming up. Details are mentioned below PID: CISCO1921/K9 PID: HWIC-3G-GSM IB_1616_KNL_IMT_MANESAR#sh cellular 0/10 /0 al...
Hi Tech Guys, Could you share some guide about calaculation Oversubscription ratio between Access to Distribution and Distribution to Core,For example for Cisco 9400 per slot capacity is 80Gbps and and how can we use 24 Port 10G Moudule which i...
good day. ISR 4351/K9 IOS 16.09.04 i need to make "ip nat inside source static" for range 5100-5200 tcp ports. i have find code, like next: ip access-list extended 190permit tcp host 192.168.0.10 range 5100 5200 any!route-map MAP_RST permit 10m...