show diag shows that module is inserted into the router, but show ip int brief and show interface doesn't show the integrated-service-engine interface
Integrated Service Engine-2 Port adapter, 1 port Port adapter is disabled deactivated Port adapter insertion time unknown EEPROM contents at hardware discovery: Hardware Revision : 1.0 Part Number : 73-11062-02 Top Assy. Part Number : 800-28761-03 Board Revision : A0 Deviation Number : 96143 Fab Version : 01 PCB Serial Number : FOC12210M0N RMA Test History : 00 RMA Number : 0-0-0-0 RMA History : 00 Product (FRU) Number : NME-WAE-522-K9 Version Identifier : V03 CLEI Code : IPUIA6SRAA
The gateway should be running 12.4.22T train image (example: c3845-adventerprisek9_ivs_li-mz.124-22.T.bin)
Step By Step Instructions to Configure Integrated Service Module
interface Integrated-Service-Engine2/0 ip unnumbered GigabitEthernet0/0.433 service-module ip address 10.4.33.99 255.255.255.0 service-module ip default-gateway 10.4.33.1 no keepalive ! ip route 10.4.33.99 255.255.255.255 Integrated-Service-Engine2/0
cvp-3845#service-module integrated-Service-Engine 2/0 status Service Module is Cisco Integrated-Service-Engine2/0 Service Module supports session via TTY line 130 Service Module is in Steady state Service Module heartbeat-reset is enabled Getting status from the Service Module, please wait.. Cisco Wide Area Application Services Software 4.0.17 (b14 Feb 27 2008 21:55:04) Restarted at Wed Aug 2 00:00:41 2006
Good morningI would like to ask about something I want to know about 3750g.Currently the 3750g is equipped with SSH, but I am trying to change the port number this time.However, the port did not change to 12.2.55-SE12 version.Is it possible to change the ...
Hello.I'm using three 3850 Stack units.We're going to use an additional 3850 this time.1. I will need the Stack Data cable and the Stack Power Cable recabling. Do I have to turn off the power and work on the old switch as well as the new one? Or is it OK ...
Hello,i am facing a problem with setting up a new cisco phone, when i connect the phone with the cabel it does not start at all and the screen stays black but when i connect my laptop to the same port it works well and the laptop gets internet connection,...
Hi,I am unable to add two statements to an existing access list. I do understand that the ip's 10.2.22 and 10.2.21 are part of the already allowed subnet 10.0.0.0 but i need to remove statement 40 while adding statement 60 and 70. But if i remove statemen...